![]() ![]() We can see here are the two new Virtual Networks. We will follow Step2 again and create the 2nd Virtual Network VMnet3, assign the subnet 33.33.33.0/24 and also change the DHCP Settings. To set the specific range of IP for the host click on DHCP Settings and specify the range of IP. If we want to assign IP address automatically to our hosts (PCs or VMs or Servers), we can use the DHCP service which is the part of this Virtual Network. ![]() You can see that a new Virtual Network has appeared VMnet2 in the Virtual Network Editor and it has a default subnet, e.g., 192.168.228.0 with subnet mask 255.255.255.0. But we will not use the given subnet, instead we will change it to 200.200.200.0/24. Click on Add Network and select the VMnet ( VMnet2) from the drop down list and click on OK. Then click on Change Settings first, so as to allow us creation of Virtual Networks. Start your VMware workstation software and open the Virtual Network Editor through Edit menu of VMware. We will achieve the fully working topology as shown above, by following the steps in this Visual Guide created by: Meena, Sr. For that we need, two routers (ISP-India, ISP-US), two hosts (, Client), and two Virtual Networks: We will create and configure the above topology. The idea is to provide the helping tool to candidates aspiring to practice and obtain their CCIE, CCNP, CCNA certifications. Two approaches of this integration has been elaborated & presented in this visual guide. The ultimate guide to understand the nuances of integrating GNS3 with VMWare WorkStation version 10/11/12. Posted in IT & Networking Blog Objectives Of 15-Steps Visual Guide VMWARE WORKSTATION PRO 14 LAN SEGMENTS HOW TOHow to Integrate GNS3 With VMWare Workstation Easily? ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |